Lanzar Car Audio E540P - Manual (Page 9)

owner’s manual operation
preamp equalizer
Control/Connector Function
2
Power Indicator LED This LED is illuminated when the unit is
properly powered, grounded and the remote
power has been turned on.
3
Equalizer Controls This seven-band equalizer’s rotary controls
give you control over musical frequency
ranges.
7
Power Connection Connect to power source as follows:
+12
: Connect a red wire of at least 12 gauge to
the car battery or other power source.
GROUND: Connect a black wire of at least 12 gauge
to car chassis for ground connection
REMOTE: Connect an orange wire to remote
activating (
12
V DC)wire of car stereo or other
head unit.
These rows of LEDs display the Preamp
Output Level. Left and right \channels are
displayed independently at peak levels. 1
LED Level Display
4
Volume Control Allows adjustment of sound level for particular
program material or source.
• In a 2 Speaker system, the fader control
should be rotated to the position which
provides highest levels for both sets of
speakers.
5
Fader Control • In a 2 Amplifier, 4 Speaker system, rotating
the knob to the FRONT side increases the
level of the front speakers; rotating to the
REAR side increase level of the rear speakers.
At mid position, both sets of speakers are at
maximum level
6
Line Channel Inputs RCA cables are used to connect the front
input signal from head unit or other source.
8
Front Channel Outputs RCA cables are used to connect the front
channel ouputs to the front channel amplifier
inputs.
9
Rear Channel Outputs RCA cables are used to connect the rear
channel ouputs to the rear channel amplifier
inputs.
s
)
5