Little Wonder PRUNER - Manual (Page 6)

5
1. Unscrew the mounting nut from the Gear Case Cover.
Open the cover. (Picture 3)
2. Mount the Chain Guide. Be sure that threaded pin fits into
the opening in the guide bar. (Picture 4)
3. Fit the saw chain into the groove in the Chain Guide bar,
and around the sprocket.
4. Be sure that pin of the chain tensioner fits into the lower
hole of the guide bar. (Picture 4)
5. Be sure the orientation of the Chain is correct.
(Pictures 5 and 6)
6. Hold it in place, and put Gear Case Cover over the
threaded pin. Attach mounting nut. Do not tighten.
(Picture 7)
7. Adjust the tension of the chain and tighten the nut.
(Picture 8)
Assembling the Pruner (installing the saw chain)
With a basic understanding of kickback, you will reduce or
eliminate the element of surprise that may contribute to an
accident.
Kickback may occur when the moving saw chain at the nose of
the guide bar touches an object, or when the wood closes in
and pinches the saw chain in the cut. In some cases, this may
cause fast reverse action, kicking the unit up and back or down
and back towards the operator. The operator can lose control of
the device, and that could result in serous personal injury.
Kickback
WARNING DANGER
CHAIN HAS A VERY SHARP EDGE, HANDLE WITH
CARE. ALWAYS WEAR GLOVES; OTHERWISE
SERIOUS PERSONAL INJURY MAY RESULT!
Picture 3
Picture 7 Picture 8
WARNING DANGER
PAY ATTENTION TO THE CORRECT DIRECTION
OF THE CHAIN SAW TEETH
Keep a firm grip on the pruner handles at all time!
Picture 6
Direction of the chain movement
35. Securing the extension cord.
Bend the extension cord about 15 inches from the plug
end. Push that bend through the oblong opening in the
back of the handle. Then loop the bend under the
cord retaining clips as
shown. This will prevent
the extension cord from
detaching from the hedge
trimmer plug.
Picture 4
Threaded pin
Opening in guide bar
Pin of the
chain tensioner
Picture 5
Correct direction
of chain links