Lennox Hearth H6963 - Manual (Page 3)

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 3
Step 2. Hook the television assembly onto
the screen rod pins and let the unit hang in
position. Plug the television power cord
into the top receptacle routing behind the
television latch (
see Figure 3 ).
Step 3. The television assembly will rotate
up into the unit and lock onto the latch rod.
See Figure 2.
CAUTION: THE TELEVISION ASSEMBLY
IS HEAVY. PLEASE CLEAR THE AREA IN
FRONT OF THE FIREPLACE BEFORE
ATTEMPTING TO SWING THE UNIT INTO
POSITION. THE UNIT MUST SWING
SLIGHTLY PAST HORIZONTAL TO LATCH.
WE SUGGEST THAT TWO PEOPLE PER-
FORM THIS STEP.
Step 4. Two locking screws have been
provided to secure the television assembly
after installation. Locate the two slots in
the assembly immediately in front of the
latching rod. Hand tighten the screws
completely into the inserts on both sides.
Step 5. Refer to Figure 1 for the location of
the door track and install at this time. Two
door clips have been provided with these
instructions.
Step 6. Locate the Television RCA cord,
suspended from the fireplace top. Connect
this cable to the jacks located at the front of
the television. The red cable connector is
for sound and connects to the audio jack at the front of the TV (
see
Figure 5 ).
The other connector may be white or yellow. This connector is for
the video and connects to the yellow jack in the front of the televi-
sion. Attach the IR transmitter to the television at the location
shown in
Figure 5. Placing this correctly is very important.
UNIT ACTIVATION
The unit is ready to power-up for the first time.
At this time all connections should be made and tested to assure
proper operation.
Locate the circuit breaker for the fireplace at the main electrical
source and turn it on. Press the power button on the remote. The
ember light will come on.
The DVD is configured to play automatically and the television is set
to receive the DVD signal directly. If the operation is correct, and
image of the flame should be on the Television and sound should be
coming from the unit.
Note: The television set will turn on about 15 seconds after the DVD
player is on.
Figure 5
IR Transmitter Location
Figure 6
Center Grate On Ember Bed And Center
Both Against The Back Of Firebox
Inserted Grate End Into Grate Bracket Grate Bracket
COMPLETING THE ASSEMBLY
After all functions are tested the assembly can be completed.
Install the side refractory panels at this time. Be sure to select the side
that align best with the back grout pattern.
1. Place the ember bed against the back wall of the fireplace, over the
ember compartment.
2. Slide the grate brackets with the square hole towards the rear and
over the grate bar, as shown in
Figure 6.
3. Insert the grate end bars under the front rectangular cut-out and
all the way into the square holes in the grate brackets.
4. Place the grate onto the ember bed as shown in Figure 6. Use
the back brick pattern as a guide to center the grate.
5. Assemble the logs onto the grate as identified in Installing The
Logs on page 4
.
6. Pour elements of the loose embers over and around the ember bed
to your liking. Turn on the unit to help judge the look of the ember
placement. It is best to pour all of the material to cover the leading
edge and spreading the embers from there.