Lathem PayClock PC400TX - Manual (Page 12)

6 - PC400 Terminal Installation & User’s Guide
Desktop Mount - To install the back box
♦ Locate a flat surface. Make sure you can plug the terminal into a 110VAC wall
outlet (220VAC in Europe and other areas), which should be no farther than 4 feet
from the terminal.
♦ Remove one of the back box knockouts, so you can run the communication cable
and 9VAC power pack cable to the clock.
♦ Rotate the back box as illustrated below. Secure the power and communications
cable to the back box by inserting supplied Tie Wrap(s) through the raised strain
relief points; see Figure 2.
♦ Align the slots on the back of the clock with the tabs on the back box. Plug in the
power pack and communications cable, and then lower the clock into place.
♦ Turn the key and lock the clock in place.
Note: Install rubber feet (not included) on bottom of back box to prevent marring of the
desktop.
Figure 2
Raised Strain Relief Points.
To use these, slide the tie wrap
through the raised slot(s) and
secure around cable and power
cord.