Lincoln Electric Invertec V205-T - Manual (Page 64)

Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
TROUBLESHOOTING & REPAIR
F-28 F-28
V205-T AC/DC
BUS BOARD TEST (continued)
TEST PROCEDURE
1. Remove input power to the V205-T machine.
2. Using a phillips head screwdriver, remove the
case wraparound cover.
3. Perform the Capacitor Discharge
Procedure detailed earlier in this section.
4. Locate the Bus board and associated plugs .
Do not remove plugs from the board. See
Figure F.11.
5. Carefully apply the correct input voltage to
the V205-T and check for the correct volt-
ages per Tables F.5, F.6, F.7, F.8 & F.9
6. Machine should be set to “STICK” mode.
FIGURE F.11 BUS BOARD LOCATION
BUS BOARD