Lanzar Car Audio SD43MU - Manual (Page 20)

Radio Operation
Start Searching For a Station
Setting Memory
Press the /CH 1-6 button repeatedly
on the front panel to preset stations at
radio mode .
Or touch the screen the
1-6 sections
(
)
1 2 3 MOD
6 4 5 BND
ST DX DISC-IN
CH
6
SWF POP 11:08 AM
FM1 98.10
MHZ
Touch to preset station
With this system, a total of 30 stations
can be stored in the memory of six
buttons. Each band stores up to six
preset stations. The stations might be
FM1, FM2, FM3, AM1(MW1), and
AM2(MW2) band.
The operation is as below :
Touch the BND section on the
touch screen to select the band ,
screen band will show in turn :
Selecting The Frequency Band
FM1 FM2 FM3
AM2(MW2) AM1(MW1)
BND
You can also press the BND on front
panel repeatedly to select the band .
(
)
19
Listening to the Radio
Storing Stations In Memory
-Retrieve a preset station
Touch the 1-6 sections briefly (or press
the /CH1-6 button repeatedly) to
retrieve a station which had been stored
in the memory in advance the chose
number is shown on display .
Switching To Radio Mode
MOD
the following information will appears on
the display :
1 2 3 MOD
6 4 5 BND
FM1 98.10
MHZ
ST DX DISC-IN
CH
6
SWF POP 11:08 AM
Touch the MOD range on the
touch screen to select the
RADIO mode
You can press
the MOD button on the panel
. (
)
In Radio mode, touch the “ ”section of
the touch screen( or press the “ ” on
the panel .) briefly to increase frequency
by one step of channel spacing .
Touch the “ ”section (or press the “ ”
button on the front panel briefly) to
decrease frequency by one step of
channel spacing .
Manual Search
Automatic Search
During Radio mode, touch and hold the
section on touch screen(or press
and hold the / button on panel) for
about 2 seconds to start search for a
radio station automatically .
/
-Store in Memory
Touch and keep the 1-6 sections
(or press and hold the
/CH 1-6) for
about 2 seconds, the current listening
station will be stored into the
number location
.