Lopi Freedom Bay Fireplace Insert - Manual (Page 10)

10 Installation
(for qualified installers only)
© Travis Industries 100-01163 4041129
Drafting Performance
This appliance relies upon natural draft to operate. External forces, such as wind, barometric pressure,
topography, or factors of the home (negative pressure from exhaust fans, chimneys, air infiltration, etc.),
may adversely affect draft. Travis Industries can not be responsible for external forces leading to less
than optimal performance.
Leveling Bolt Installation
Two leveling bolts are included to level the insert if the fireplace has a stepped-up hearth. To install, raise
the rear of the insert up and insert the leveling bolts into the holes in the rear corners of the insert. Adjust
the bolts until they extend the same height as the hearth steps up. After the insert is installed, fine-tune
the leveling bolts to level the insert (see Figure 4).
This distance is the
hearth step-up. The
leveling bolts should
stick out this far from the
base of the insert.
Fireplace
Hearth
The leveling bolts go
into the holes at the
rear corners of the
insert.
Figure 4
Blower Installation
The included blower is fragile and should be installed last (see the directions below).
Remove the two
screws underneath the
ashlip with a 3/8"
nutdriver. Align the
blower under the
ashlip and replace the
two screws to secure.