Lucent Technologies 9077 16S - Manual (Page 66)

2-32 October 22, 1999 SP Switch Router Adapter Guide - 1.4 Update 2
Configuring the SP Switch Router Adapter
Step 4. Run dev1config to create grdev1.conf
Contents of /etc/grdev1.conf
Here is an excerpt from the /etc/grdev1.conf configuration file. It shows only the slot 0
card interface entry.
– SNMP expects 16 interface entries, so do not remove any even if they will be unused.
– Leave the “x” in place in front of the IP address and Net Mask parameters.
# more /etc/grdev1.conf
#####################################################################
# DEV1 Configuration
#####################################################################
# There are several variables that an SP Adapter card needs at
# start up. These are handled by a set of GRINCHES whose descriptors
# are indexed by card number and interface number as follows:
#
# 2.21.{CARD+1}.1.{INTERFACE+1}
#
# This template specifies the start-up values for all potential cards
# in a 16-card GRF router. Initially these are default values
# indicating that the card needs to be configured.
#
# The descriptors are grouped by card and interface so that a
# particular interface can be easily configured.
#####################################################################
# CARD 0 Interface 0
#
-> 2.21.1.1.1.1 "00" # Extension Node Identifier
2.21.1.1.1.2 -1 # Node Name
2.21.1.1.1.3 "00:00:00:01:00:00:00:02:00:03" # Switch Token
2.21.1.1.1.4 1 # Switch ARP
2.21.1.1.1.5 0 # Switch Node Number
2.21.1.1.1.6 x0.0.0.0 # IP Address
2.21.1.1.1.7 x0.0.0.0 # Net Mask
-> 2.21.1.1.1.8 1024 # Max Link Pckt Len.(bytes)
2.21.1.1.1.9 0 # IP Host Offset
-> 2.21.1.1.1.10 1 # Configuration State
2.21.1.1.1.11 "sp_00" # System Name
-> 2.21.1.1.1.12 2 # Node State
2.21.1.1.1.13 0 # Switch Chip Link
2.21.1.1.1.14 31 # Node Delay (cycles)
2.21.1.1.1.15 1 # Admin Status
#
The arrows ( -> ) indicate read-only values that will not be changed.