Lenoxx Electronics DVD-2002 - Manual (Page 19)

1. BASIC PLAY
To Load and Play a Disc
NOTE: We call any DVD or AUDIO CD as “disc” in this booklet.
Turn on the TV and DVD player ( press ON/OFF on the player or press the POWER button on the remote control in STANDBY mode).
1
Press the OPEN/CLOSE button on the front of the DVD player or the EJECT button on the
REMOTE, wait a few seconds, the disc tray will open.
2
Place a disc gently into the tray with the disc’s label facing up (double-sided discs have content on both
sides, so you can place either side up).
3
Press the OPEN/CLOSE or PLAY button, the disc tray will close.
The DVD player reads the disc’s table of contents (this may take a few seconds) with a loading icon
“
” on the left upper corner of the screen, and then one of the three things happens depending on how
the disc was programmed:
•
The disc starts playing.
•
The disc menu appears on the screen. One of the options will be “Start Disc Play”. Highlight that
option and press the SELECT button or PLAY button.
•
The DVD Player’s main menu appears on the screen. Highlight the Play option and press
SELECT button.
5
Press STOP button to stop play.
6
After play, press OPEN/CLOSE or EJECT button to open the tray and take the disc out of the disc tray.
NOTE: When player is stopped, the display will show “Pre Stop”, the player records the point where
STOP was pressed (RESUME function). Press PLAY again, playback will resume from this point.
When the tray is opened or STOP is pressed again, the return function will be cleared and the set
is fully stopped.
4
Press VOLUME UP or DOWN button to adjust the volume level on your TV’s REMOTE and DVD’s
REMOTE.
Open Close Loading Play
can 't ca tc h up (w ides creen versions ) c an 't ca tch up
Great Movie
Great Movie
This is an example of a
one-sided disc.
This is an example of a
2-sided disc. The title is
in the center.
18
IB-DVD-2002-WC-ZR-E-V1