Wiring the fault alarm contact, Iring the, Ault – LevelOne Industrial PoE IFE-0500 User Manual
Page 13: Larm, Ontact
Advertising
![background image](/manuals/167149/13/background.png)
Wiring the Fault Alarm Contact
The fault alarm contact is in the middle of terminal block connector as the picture
shows below. When the wires are inserted into ports 3 and 4, they automatically
detect the fault status in the event of a power failure by forming an open circuit.
An example for the fault alarm contact is shown as below:
Insert the wires into the fault alarm contact.
The wire gauge for the terminal block should be in the range
between 12~ 24 AWG.
13
Advertising