Lanier 5622 - Manual (Page 20)

Preparations for Use as a Network Scanner
12
2
Initial Scanner Setup
This section explains all required settings and procedures for using the machine
as a network scanner.
Default Settings
Settings to use the functions of the machine as a network scanner are listed be-
low. Make correct setting of necessary items.
Important
❒ Items marked (✩) are the minimum required settings for using the machine
as a network scanner. Be sure to set these items before use.
❒ Items marked (❍) should be set if required.
❖ ❖ ❖ ❖ System settings
For information about the explanation of settings, see the System Settings
manual.
*1 Settings for use as network TWAIN scanner
*2 Settings for use as network delivery scanner
*3 Settings for use as Document Server
*4 Do not change this setting. It must be left at the factory default value.
*5 Make sure that IP address is set.
Settings TWAIN
*1
Delivery
*2
Store *3
Clock timer settings Scanner Auto Reset Timer ❍ ❍
Interface settings
[Network]
IP Address ✩ ✩ ✩
Sub-net Mask ❍ ❍ ❍
Gateway Address ❍ ❍ ❍
Access Control ❍
Access Mask ❍
Network Boot ❍
Valid Protocol *4
❍ ❍ ❍
Ethernet Speed
❍ ❍
File transfer settings Delivery Server IP Address
*5
✩
Resend Interval Setting ❍
Resend Frequency Setting
❍