Life Fitness RT8 - Manual (Page 7)

U
NPACKING THE
R
ECUMBENT
E
XERCISE
B
IKE
1. Carefully cut and remove the SHIPPING BANDS.
2. Carefully cut the tape securing the TOP FLAPS.
3. Fold the TOP FLAPS outward fully.
4. With the help of another person, remove the SIDE SHIP-
PING TRAY.
CAUTION: Be sure to keep the left and right sides of
the side SHIPPING TRAY together while removing it
from the SHIPPING CARTON.
5. Remove the DISPLAY CONSOLE carton and the ACCES-
SORY TRAY from beside the BASE UNIT.
6. With the help of another person, lift the BASE UNIT from
the SHIPPING CARTON. Remove the protective packag-
ing from the unit.
A
SSEMBLING THE
R
ECUMBENT
E
XERCISE
B
IKE
Tools Required: Metric Wrench Set, Metric Allen
Wrench Set, Phillips Screwdriver
1. Locate and install the two LEVELER FEET (A) to the bottom
of the REAR STABILIZER (B).
2. With the bends facing rearward, attach the REAR STABILIZ-
ER (B) to the BASE UNIT (C) using two 2-3/8" BUTTON
HEAD SCREWS (1) from the top of the REAR STABILIZER
BRACKET (D) and two 13/16" BUTTON HEAD SCREWS (2)
from the front side of the REAR STABILIZER BRACKET.
Tighten the SCREWS securely.
3. Locate the HANDLEBAR ASSEMBLY (E) and the SEAT
ASSEMBLY (F). With the handlebars facing upward and for-
ward, align the mounting holes of the HANDLEBAR ASSEM-
BLY with those in the SEAT ASSEMBLY. Secure the HAN-
DLEBAR ASSEMBLY to the SEAT ASSEMBLY using four
5/8" BUTTON HEAD SCREWS (3) and FLAT WASHERS (4).
Tighten the SCREWS securely.
4. Locate the two CABLE TIE CLIPS (G) and CABLE TIES (H).
Feed one CABLE TIE through each CABLE TIE CLIP. Using
one 1/4” PHILLIPS HEAD SCREW (5) each, secure the
CABLE TIE CLIPS to the SEAT ASSEMBLY WELDMENT
HOLES as shown.
6