Linear AE-1000 - Manual (Page 18)

18
AE-1000 Operation
Requesting Access with an Entry Code
• Residents have up to 40 seconds to key in their entry code.
• Up to eight seconds are allowed between each keystroke.
• All digits of the entry code must be entered. Example: If the entry
code length is set for four digits, and the code is 0042, the user
must enter “0 0 4 2”.
• If the wrong key is pressed, pressing the key will reset the
keypad. The correct code can then be entered.
• After a correct code is entered, and if the conditions for granting
access are fulfi lled, the programmed relay will activate for the
programmed time.
• If the number of incorrect codes entered exceeds the keypad
lockout count, the keypad will be locked and not accept any entries
for one minute.
• If the Anti-passback feature is enabled, the entry code will be
unusable until the anti-passback time expires.
Requesting Access with a Wireless Transmitter
• Activate a wireless transmitter within radio range of the AE-1000’s
antenna.
• After a valid transmitter is decoded, and if the conditions for
granting access are fulfi lled, the programmed relay channel will
activate for the programmed time.
• If the Anti-passback feature is enabled, the transmitter will be
unusable until the anti-passback time expires.
Requesting Access with a Visitor Call
• Press to view the directory.
• The visitor scrolls through the alphabetical directory entries
viewing the resident names and associated directory numbers
by pressing
& on the keypad. (Holding down the keys will
scroll the display faster.)
• If the visitor already knows the resident’s directory number, they
can enter the directory number to call the resident.
• The system dials the resident’s telephone number to establish
2-way communications.
✦ NOTE: The resident’s telephone number will never be displayed to
the visitor.
• If the resident is using the telephone at the same time a visitor
calls, the display will indicate to the visitor that the line is busy.
• The resident answers the call and converses with the visitor to
determine if access will be granted.
• The resident can use their telephone’s keypad to grant access
activating Relay Channel “A” by pressing , or activating Relay
Channel “B” by pressing . After access is granted, the system
will disconnect the visitor and resident call.
• The resident can disconnect the visitor without granting access by
pressing or by hanging up.
✦ NOTE: The telephone keys that the resident presses can be
customized for the installation.
• The length of time the visitor is allowed to talk can be programmed
from 15-255 seconds. The resident will hear a series of beeps
during the last 10 seconds of talk time. To restart the talk timer, the
resident can press on their telephone.
220777 C IMAGE18
ENTRY CODE AT REMOTE KEYPAD ENTRY CODE AT LOCAL KEYPAD
ACTIVATE TRANSMITTER
ANTENNA
ENTER DIRECTORY NUMBER
OR PRESS
OR
SCROLL THROUGH THE RESIDENT
NAMES
2
TO
PRESS
TO VIEW DIRECTORY
1
3 AFTER SCROLLING, ENTER THE RESIDENT'S
DIRECTORY NUMBER AND TALK
WITH THE RESIDENT THE RESIDENT CAN CONTROL
ACCESS USING TELEPHONE KEYS
RELAY "A"
RELAY "B"
DISCONNECT
VISITOR
TENANT