Lenovo ThinkVision L190 - Manual (Page 11)

ENGLISH
9
Connecting your monitor
1. Turn off your computer and all attached devices. Next, unplug all power
cords to your computer and all attached devices.
2. Connect the signal cable.
• The analog signal cable is already connected to your monitor
(See in Figure A).
• When connecting the analog signal cable, connect the free end of the
attached signal cable to the 15-pin monitor port on the computer and
tighten the screws.
Figure A
Be sure to read the Safety
Information located in the Monitor
Safety, Troubleshooting, and
Warranty booklet before carrying
out this procedure.
3. Connect the power cord to the monitor and then plug the power cord into
a properly grounded outlet. Next, reconnect the power cords to your
computer and all attached devices.