Life Fitness Lifestyle Exercise Bike LC8500 - Manual (Page 9)

CAUTION: Do not attempt to adjust the seat while pedaling the bike. Doing so, or failing
to insert the seat pin completely may result in an uncomfortable workout or cause injury.
MISE EN GARDE : Ne pas essayer d'ajuster la selle pendant le pédalage. Tout
ajustage en cours de fonctionnement ou toute insertion incomplète de la goupille de la
selle pourrait nuire à l'exercice ou entraîner des blessures.
H
OW TO
A
DJUST THE
P
EDAL
S
TRAPS
The bike pedal straps keep the user’s shoes on the pedals during a workout. The straps should fit
comfortably, but they also should be tight enough to prevent shoes from slipping at any point in the
pedaling rotation. Before working out, a user should test and adjust the tightness of the straps.
On the 9100: The safety straps on the foot pedals of the
Lifecycle recumbent bike can be adjusted to fit a variety of shoe
sizes. The straps are held in place by two knobs that extend
from either side of each pedal. The “inner” knob extends side-
ways, that is, toward the bike. The “outer” knob extends down-
ward. The ends of each strap are perforated with slots that fit
tightly over the knobs. The “inner” end of each strap is perforat-
ed with two slots, and the “outer” segment of the strap is perfo-
rated with a row of slots. To tighten or loosen a strap, grasp the
outer end, and pull it back, away from the knob, until the strap
slides off. Pull the strap out through the outer loop on the pedal.
Rest the foot on the pedal, and wrap the strap over the foot to
determine the proper length. Thread the strap through the outer
loop on the pedal, tuck it under the pedal, select the appropriate
slot, and pull that slot down over the knob, until the top of the
knob pops through the slot. A click indicates that the strap is
locked into place.
8