Lanier 1027 - Manual (Page 172)

Troubleshooting
160
3
B B B B Loading Paper
Loading Paper in Tray 1-4
Note
❒ You can change the paper size. ⇒
p.170 “Changing the Paper Size”
Reference
Regarding paper types and sizes,
⇒ p.22 “Copy Paper”.
AAAA
Pull out the paper tray until it
stops.
BBBB
Square the paper and load it in
the tray with the copying face up.
Important
❒ If you add paper to a paper tray
where paper is still left, a mis-
feed might occur.
❒ Do not stack paper over the lim-
it mark.
❒ When setting small quantities of
copy paper, be careful not to
squeeze in the side fence too
much or paper will not be fed
properly.
Setting special paper in the
Paper Tray 2
A A A A
Set the special paper below the
limit mark of the tray.
Note
❒ Shuffle the paper before
loading it in the tray.
❒ When copying onto paper
such as translucent paper,
straighten curled or warped
paper before placing it in the
tray.
CCCC
Push the paper tray in until it
stops.