Linksys BEFSR81 User Manual

Page 40

Advertising
background image

34

Chapter 7: Using The Router’s Web-based Utility
Management

EtherFast Cable/DSL Router with 8-Port Switch

Remote Router Access

This feature allows you to access the Router from a remote location, via the Internet.

•

Remote Upgrade. Remote Upgrade allows you to upgrade the Router’s firmware from a remote location. To
enable this feature, click the Enabled radio button. Remote Administration must be activated before you can
access the Router from a remote location.

•

Remote Administration. This feature allows you to manage the Router from a remote location, via the Internet.
To enabled Remote Administration, click the Enabled radio button.

•

Administration Port. Enter the port number you will use to remotely access the Router.

SNMP

The Router supports Simple Network Management Protocol (SNMP), which is a widely used network monitoring
and control protocol. This allows network supervisors to monitor the Router using network management systems
such as HP OpenView.

•

Enabled/Disabled. To use SNMP, select Enabled. If you do not want to use SNMP, keep the default, Disabled.

Identification

•

Contact. Enter the name of the contact person for the Router.

•

Device Name. Enter the name of the Router.

•

Location. Enter the location of the Router.

•

Get Community. Enter the password that allows read-only access to the Router’s SNMP information.

•

Set Community. Enter the password that allows read/write access to the Router’s SNMP information.

Note: When you are in a remote location and wish to manage the Router, enter http://<Internet IP
Address>: port
. Enter the Router’s specific Internet IP address in place of <Internet IP Address>, and
enter the Administration Port number in place of the word port.

Note: You can use a standard Management Information Base (MIB) II file with the Router; no special
MIB file is required or provided.

Advertising