Lenoxx Electronics CR-500 - Manual (Page 6)

IB-CR500-WM-E-123003
TROUBLE SHOOTING
(Helpful Hints)
SHO ULD YO UR SET EXHIBIT A PRO BLEM, CHECK THE
FOLLOWING BEFORE SEEKING SERVICE.
FM is distorted
and weak.
Noise or weak
sound on AM
broadcasts.
No sound.
The clock is
flashing.
Clock is dead.
FM antenna wire is
not extended.
Station not tuned in
properly.
Weak broadcast
station.
Signal is blocked.
External
interference.
FUNCTION switch is
in the OFF position.
VOLUME control set
to minimum position.
The clock is not set.
A power failure has
occurred.
The set’s AC cord is
not connected.
Extend FM antenna
wire.
Tune to desired station
carefully.
Turn to a stronger
Station.
Rotate the set to
receive better signal.
Turn the radio for better
AM reception or bring
the set near a window.
Slide the FUNCTION
switch to ON position.
Rotate VOLUME control
for desired sound.
Set the clock and alarm
time.
Reset the clock alarm
time and time of the day.
Connect the set’s AC
cord and make sure
outlet has power.
LENOXX reserves the right to make design and specification
changes for product improvement.
SYMPTOM CAUSE SOLUTION
Alarm does not
come on in the
morning.
AM or PM not set
correctly. Is alarm
time set in AM range
(PM Lamp off)?
Advance the clock 12
hours.
FUNCTION switch
is in OFF position. Is
the AUTO Lamp off? Set the FUNCTION
switch to AUTO or
ALARM position.
PROTECT YOUR FINE FURNITURE!
WE RECOMMEND A CLOTH OR OTHER PROTECTIVE MATERIAL
BE PLACED UNDER THE SET WHEN PLACING IT ON SURFACE
WITH A NATURAL OR LACQUER FINISH.
5
IB-CR500-WM-E-123003.p65 4/20/2004, 2:34 PM 6