Lenoxx Electronics IB-PH5595 - Manual (Page 19)

IB-PH5595-WM-E-032704
To erase ALL call records, make sure the phone is
not in use, press the DELETE button and hold
for 3 seconds, the display will show “DELETE
ALL?”, press the DELETE button again.
CHECK
NOTE :
1. If problems with your telephone service occur later, try to determine if the trouble is with
the telephones you own or with the telephone company equipment. Unplug the tele-
phone and try it on another jack in a different room or in a neighbor’s home to see if the
phone line is bad or the phone.
If the known working phone does not operate properly on that line, contact your local
telephone company for assistance.
2. If disconnection of your phone ends the problem, your phone may be the source of the
trouble and it should be tested and repaired if necessary before it is re-connected.
3. There are no user maintainable parts or adjustments on this set. Should your phone
require repairing, contact us for instructions (except for cords which you can buy at any
phone store).
Check with your telephone company if this service
is available and if you have subscribed for it.
The caller may have an unlisted or blocked
number to prevent Caller ID identification, or it
may be an overseas call or you may have noise
on the line during that call.
You picked up the phone before the second ring,
or your phone received unclear call information.
Static can cause this message.
If this condition persists, contact your local
telephone company to ensure that there is no
problem with your phone line.
Handset clip was not installed properly for wall
use. See page 14 for details.
17
TROUBLE SHOOTING (continued)
appears in the display
Cannot erase all records in memory
Caller ID displays words like ,
or or or
.
Check if you have stored the numbers correctly by
pressing that memory location button(s). Also
numbers can only be stored when fresh batteries
are installed correctly.
Memory Dialing does not work
Handset falls out of phone base when wall
mounted
Caller’s information is not registered to the
Caller ID memory
Call Waiting or Message Waiting does not
work
Pressing a Memory button does not
display number
Your MEMORY button has no stored number.
Please store the number again. Press the STORE
button, dial the number and press the MEMORY
locations you want.
PROBLEMS
Call waiting does not show the number
If an extension phone was picked up on call 1,
this phone will not decode the call waiting, Caller
ID signals, if the extension phone is not a call
waiting caller ID phone.
Your language is set for French or Spanish. To
reset the language, press the MENU button and
then press the UP button, the display will go to
the language setting, press the MENU button
again then press the DOWN button. When is
flashing, press MENU button to confirm. The
language will be set to English mode.
IB-PH5595-WM-E-032704.P65 4/8/2004, 3:17 PM 19