Lowrance electronic LMS-160 - Manual (Page 8)

2
Power Connections - All Units
This unit works from a twelve-volt battery system. For the best results,
attach the power cable directly to the battery. You can attach the power
cable to an accessory or power buss, however you may have problems
with electrical interference. Therefore, it’s safer to go ahead and attach
the power cable directly to the battery. If the cable is not long enough,
splice #18 gauge wire onto it. The power cable has two wires, red and
black. Red is the positive lead, black is negative or ground. Make certain
to attach the in-line fuse holder to the red lead as close to the power
source as possible. For example, if you have to extend the power cable to
the battery or power buss, attach one end of the fuse holder directly to the
battery or power buss. This will protect both the unit and the power cable
in the event of a short. Use a 3-amp fuse.
IMPORTANT!
Do not use this product without a 3-amp fuse wired into the power cable!
Failure to use a 3-amp fuse will void your warranty.
3-AMP
FUSE
12-VOLT
BATTERY
3-AMP
FUSE
12-VOLT
BATTERY
TO
TRANSDUCER
RED
BLACK
RED
BLACK
LMS-160
POWER CONNCECTIONS
GLOBALMAP-1600
POWER CONNCECTIONS