Lopi 564 - Manual (Page 6)

Bostonian (564) Wilmington Face
Black 95400186 Carbon Patina 95400194
Page 6 of 6 17601480 5/13/13 © Travis Industries, Inc.
2 Place the face, face down, on a soft, non-scratching surface. Install the 564 Electric mounting brackets onto
the back of the face.
a
Remove and
discard the
hinge assembly
from the face.
d
Attach the 564 E hinge bracket. Use
the nuts removed earlier.
Attach the 564 E side bracket.
Use the nuts included with
this kit.
Repeat steps “a” through
“c” for the opposite side.
e
Before installing the face
verify the lower grill is
centered. Loosen the nuts
and adjust if necessary.
b
c
3 Pull the electric fireplace out of the mantel (or built-in location). Attach the cove cover and face following the
directions below. Slide the fireplace back into place to complete the installation.
Tilt the face back slightly and insert the
bottom hooks into the slots on the fireplace.
Lift the face up slightly, tilt
it forward and insert the
top hooks until the face
locks in place.
b
c
Hang the 564 E cove
cover over the glass -
this keeps light from
exiting the grill opening
along the top of the face.
a