Ftp settings, To configure ftp, Figure 9-6 ftp configuration – Lantronix XPORT PROTM 900-560 User Manual
Page 70: Table 9-7 ftp settings
9: Service Settings
XPort Pro User Guide
70
3.
Click Submit.
FTP Settings
The FTP web page shows the current File Transfer Protocol (FTP) configuration and various
statistics about the FTP server.
To configure FTP:
1.
Select FTP on the menu bar. The FTP page opens to display the current configuration.
Figure 9-6 FTP Configuration
2.
Enter or modify the following settings:
Table 9-7
FTP Settings
System Description
Enter the system description.
System Location
Enter the system location.
Traps State
Select Enabled to enable the transmission of SNMP Traps.
The Cold Start trap is sent on device boot up, and the
Linkdown trap is sent when the device is rebooted from
software control.
Traps Primary Destination
Enter the primary SNMP trap host.
Traps Secondary
Destination
Enter the secondary SNMP trap host.
FTP Settings
Description
State
Select Enabled to enable the FTP server.
Admin Username
Enter the username to use when logging in via FTP.
SNMP Settings (continued)
Description