LG 26LT560C User Manual
Page 7
7
ENG
ENGLISH
TABLE OF CONTENTS
TABLE OF CONTENTS
2
LICENSES
2
OPEN SOURCE SOFTWARE NOTICE
3
IMPORTANT SAFETY INSTRUCTIONS
7
TABLE OF CONTENTS
8
INSTALLATION PROCEDURE
8
ASSEMBLING AND PREPARING
8
Unpacking
10
Optional Extras (For LT560E series)
11
Parts and buttons
12
Setting up the TV
12
- Attaching the stand
14
- Mounting on a table
15
- Mounting on a wall
17
- Tidying cables
17
- External speaker out
18 REMOTE CONTROL
20 GENERAL TROUBLESHOOTING
20 CAUTION FOR USING EzSIGN 2.0
21 SPECIFICATIONS
23 IR CODES
24 EXTERNAL CONTROL DEVICE SETUP
24
RS-232C Setup
24
Type of connector;
D-Sub 9-Pin Male
25
RS-232C configurations
26
Communication Parameters
26
Command reference list
27
Transmission / Receiving protocol
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation of the device.
Any changes or modifications in construction of this device which are not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.