La Crosse Technology WS-7059-SU - Manual (Page 20)

20
B. The TX4U Remote Sensor
1. Mounting with screws
a. Remove the mounting bracket/ receptor from the
packaging.
b. Place the mounting bracket over the desired
mounting surface. Through the 2 screw holes of
the bracket, mark the mounting surface with a
pencil.
c. Where marked start screw holes using the
provided screws. Remove screws from the
mounting surface.
d. Align the mounting bracket with the started
screw holes.
e. Screw the mounting bracket onto the mounting
surface (the screws should be flush with the
surface).
f. Fit the mounting post (on the back of the sensor)
into the receptor of the mounting bracket.
2. Mounting with adhesive tape
a. With a nonabrasive solution, clean and dry the
back of the mounting bracket and the mounting
surface to ensure a secure hold. The mounting
surface should be smooth and flat.
b. Remove the protective strip from one side of the
tape. Press firmly onto the designated area on
the back of the mounting bracket.
c. Remove the protective strip from the other side
of the tape and apply to the mounting bracket.
d. Firmly press the mounting bracket onto the
mounting surface.
e. Fit the mounting post into the receptor of the
mounting bracket.