Lathem PC2000 - Manual (Page 27)

PC2000/PC100 Terminal User’s Guide
19
A P P E N D I X B
Optional Bell Ringer
Connecting the Bell
1. Using a Phillips Screwdriver, remove and save the two (2) screws at the
bottom of your PayClock
2. Using gentle pressure, lift and separate the cover and Back-Box sections of
the PayClock by grasping the parts at the bottom opening
3. Pivot the cover section to the right, as if there were a hinge along the right
edge
4. Install jacketed control cable through the grommet in the left side wall.
Wire leads should be stripped of insulation 3/8" and, if possible, tinned
5. Install a Nylon Tie-Wrap around the cable, inside the box near the
grommet, to act as a strain-relief
6. Connector is a "Wire-Trap" type; securely accepting gauges from 20 to 18,
when inserted into the connector housing
or
Power Source
IMPORTANT! Relay contacts
provide no power for bells or
buzzers. They are rated “dry” for 2.0
amps @ 24 VDC or 1.0 amp @ 120
VAC. Bells and buzzers must use an
outside power source. Connecting a
device or series of devices that draw
more than the appropriate amperage
from the PayClock will result in
serious damage! We recommend
using the RB8 Relay Booster Box to
control devices that require more
than 2 amps. Contact your dealer for
information about obtaining an RB8.