Lopi Freedom Fireplace Insert - Manual (Page 31)

Optional Equipment 31
© Travis Industries 100-01162 4041105
Flush Kit
This kit allows the Freedom insert to be installed with more of the unit inside the fireplace (flush) rather
than extended onto the hearth. The flush kit must be installed prior to installing the surround panels or
placing the insert. Place the insert 24" onto the hearth before following the instructions below.
1. Remove the damper extension rod and pull ring from the insert. Remove the pull ring from the
extension rod and attach it to the longer extension included with the flush kit (the stock damper
extension rod may be discarded). Install the extension rod back onto the fireplace insert.
Replace this extension with the longer
extension included with the flush kit.
2. Pre-thread the 8 mounting holes on air chamber top & side extensions (see illustration below).
3. Place the air chamber side extension in place and attach with the included screws.
4. Place the air chamber top in place and attach with the included screws.
5. The surround panels attach to the air chamber side extensions in the same manner they attach to the
insert.
1.
3.
2.
Pre-thread the
8 mounting
holes on the air
chamber
extensions
using one of
the included
screws and a
5/16" nutdriver.
Place the air chamber side in place
and attach with the included screws.
Back
of
Insert
Top of Insert
Place the air chamber
top in place and
attach with the
included screws.
Use these holes
to mount the
surround panels.
Air Chamber Top
Extension
Air Chamber Side Extension
Side of
Insert