Logitech Harmony 1100 - Manual (Page 38)

38
You have a lot of fl exibility where you can install the RF Wireless Extender. You can
mount it on a wall or you can install it inside the cabinet where your devices are located.
Before you install the RF Wireless Extender, you should decide what you are doing with
the emitters. If you are attaching emitters to the devices, then the RF Wireless Extender
has to be within connecting distance to the devices. If you are not connecting the
emitters to the devices, then all of the components of your system must be within 5
metres and have a direct line of sight with the RF Wireless Extender.
Logitech recommends that you make sure all of your devices are working properly
before installing the RF Wireless Extender.
The RF Wireless Extender has four dual-head IR (infrared) emitters that can control up to
eight devices. Each emitter can control two devices.
There are 3 possible ways the RF Wireless Extender can send IR signals to the devices of
your entertainment system:
The RF Wireless Extender sends IR signals in all directions. In this case, no 1.
emitters are attached to the components or plugged into the RF Wireless
Extender. For this method to work, all of the system components must be
within 5 meters and have a direct line of sight with the RF Wireless Extender.
An emitter is attached to each of the components and each emitter is randomly
2.
plugged into the RF Wireless Extender ports. No ports are assigned for
individual components, so it doesn’t matter which emitter is plugged into A, B,
C, or D port on the RF Wireless Extender.
An emitter is attached to each of the components, individual ports are assigned
3.
to each of the components, and the emitters are plugged into specifi c ports of
the Wireless Extender.
To fi nd where to place the emitters:
Take the remote you use to turn the device on or off, move toward the device 1.
and press the power button on and off as you get closer to the device.
If the device stops responding, stop moving forward, move the remote slightly
2.
up/down/left/right until the device responds again.
Repeat Step 1 and 2 until the remote is touching the device.
3.
Installing the RF Wireless Extender
Using the Emitters
Finding where to place the emitters