Replacing the keyboard – Lenovo 5046 User Manual

Page 46

Advertising
background image

Figure 38. Installing the front fan assembly

10. Connect the new front fan assembly cable to the system fan connector on the system board. See

“Locating parts on the system board” on page 9.

11. Reinstall the heat sink fan duct. See Figure 26 “Installing the heat sink fan duct” on page 30.

12. Reinstall the hard disk drive. See “Replacing the hard disk drive” on page 34.

What to do next:

• To work with another piece of hardware, go to the appropriate section.

• To complete the replacement, go to “Completing the parts replacement” on page 40.

Replacing the keyboard

Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support

This section provides instructions on how to replace the keyboard.

To replace the keyboard, do the following:

1. Remove all media from the drives. Then, turn off all attached devices and the computer.

2. Disconnect all power cords from electrical outlets.

3. Disconnect the old keyboard cable from the computer.

4. Connect a new keyboard to the appropriate connector on the computer. Your keyboard might be

connected to a PS/2 keyboard connector

1

or a USB connector

2

. Depending on where you want

38

ThinkCentre User Guide

Advertising
This manual is related to the following products: