Lanzar Car Audio Lanzar Vibe VBD1800 - Manual (Page 10)

10
When there is a disc in, press button
(7), the panel will slide down.
Then press EJECT button (4) to stop
CD playing and eject the disc from the
disc slot (5). Press button (7) again
to slide up the front panel.
• SELECT TRACKS
Press TUNE/TRACK/SKIP button
(16) or TUNE/TRACK/SKIP button
(17) to move to the previous track or
the following track. Track number
shows on display.
Hold TUNE/TRACK/SKIP button
(16) or TUNE/TRACK/SKIP button
(17) to fast reverse or fast forward.
CD play starts from when you release
the button.
• PAUSE PLAYING
Press PAU button (19) to pause CD
player. Press it again to resume play.
• REPEAT THE SAME TRACK
Press RPT button (21) to continuously
repeat the same track. Press it again
to stop repeat.
OPERATION
You can sometimes improve reception
of distant stations by selecting mono
operation.
• SCAN
Press SCAN button (25) to set function
to scan mode, which scanning to
higher frequency station with
receivable signal and keep on each
station for several seconds.
• AUTOMATICALLY MEMORY
STORING & PROGRAM SCANNING
- Automatic Memory Storing
Press AMS button (18) for several
seconds, the radio searches from
the current frequency and checks
the signal strength level until one
cycle search is finished. And then 6
strongest stations are stored into the
corresponding preset number
button.
- Program Scanning
Press AMS button (18) shortly to
scan the preset station. When the
field strength level is more than the
threshold level of stop level, the radio
is holding at that preset number for
several seconds with releasing mute,
then searches again.
• STATION STORING
Press any one of the preset buttons
(14) (M1 to M6) to select a station
which had been stored in the memory.
Press this button for several seconds,
current station is stored into the
number button.
CD OR OPERATION
• CD OPEN/CLOSE/EJECT
When the front panel is in State 3 and
there is no disc in, press button (7),
the front panel will slide down to State
2, and then you can insert a disc into
the disc slot (5). Then the panel will
automatically slide up to State 3.
State 3
State 2
Button
Front Panel