Lanier 5565 - Manual (Page 2)

MATERIAL SAFETY DATA SHEET
Page 2 of CP-332
Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions.
On the basis of the data available to us, this product is not a dangerous substance. One should, however, observe the usual precautionary measures
for dealing with chemicals.
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner
Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue
with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
Section 7: Handling and Storage
Special Handling: Cleanse skin after contact before breaks or meals, and end of workday.
Special Storage:
Miscellaneous: Store in a cool, dry place. Avoid direct sunlight. Keep out of reach of children. Keep from contact with oxidizing
materials.
Do not handle in windy areas. Flying powder may enter eyes. Minimize inhalation of dust. Cleanse skin thoroughly
after contact, before breaks and meals, and at end of work periods.
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.
Eye Protection: none required under normal use.
Ventilation: Local exhaust equipment is needed. Skin Protection: none required under normal use.
Exposure Guidelines: USA OSHA (TWA/PEL) : 15mg/m
3 (Total Dust); 5mg/m 3 (Respirable fraction)
ACGIH (TWA/TLV) : 10mg/m 3 (Total dust); 3mg/m 3 (Respirable fraction)
DFG (MAK) : 6mg/m 3 (Total dust)
Section 9: Physical and Chemical Properties
CHARACTERISTICS:
Appearance:
Black Melting point: 110 – 150
?
C (softening point)
Form: Powder Vapor pressure: n/a
Odor: Odorless Vapor density: n/a
Solubility in Water: Negligible Evaporation rate: n/a
Density: 1.1 – 1.5 Boiling point: n/a
Flammability: N/a Fat solubility: N/a
Section 10: Stability and Reactivity
Conditions to avoid: none Materials to avoid: none Stability: Stable
Hazardous decomposition products: CO and CO2 and other decomposition products when burned.
Section 11: Toxicological Information:
Acute Toxicity: Inhalation: (Data from similar material without ferrite): LC50:>5.19mg/L/4hr (rats) (Mean maximum attainable concentration)
Ingestion: (Data from ingredients of toner): LD50:>5000mg/kg (rats)
Eye: (Data from ingredients of toner): Not classified as irritant, according to OSHA Haz Com Standard and EU Directive 67/548/EEC based on test
data of rabbits.
Sensitizer: No sensitizer according to Annex I of EU Directive 67/548/EEC and strong sensitizer list of FHSA.
Mutagenicity: Ames test negative
Reproductive Toxicity: No reproductive toxic substances according to Annex I of EU Directive 67/548/EEC, California Proposition 65 and DFG.
Carcinogenicity: Carbon Black: IARC 2B (Possible human carcinogen based on animal testing). Not listed in NTP, OSHA(USA) regulation,
California Proposition 65 and Annex I of EU Directive 67/548/EEC.
Section 12: Environmental / Ecological Information
No information indicating any adverse ecological effects.
Section 13: Disposal Consideration
Used Toner should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary
from locality to locality, therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose
or spilled Toner. Empty plastic container may be recycled.
Section 14: Transportation Information
None. This is not a hazardous product.
Section 15: Regulatory Information
SARA Title III, 313: none.
TSCA: All chemical substances in this product comply with all applicable rules or orders under TSCA.
Section 16: Miscellaneous Information