Lanner electronic FW-6420 - Manual (Page 37)

There are three selections for Power Management, three of which have fixed mode setting
Disable (Default) No power management. Disables all four modes.
Min. Power Saving Minimum power management. Doze Mode=1hr. Standby Mode =1hr.,
Suspend Mode=1hr., and HDD Power Down=15min.
Max. Power Saving Maximum power management. –Only available for SL CPU’s. Doze
Mode=1min., Standby Mode=1min., Suspend Mode=1min., and HDD Power
Down=1min
User Defined Allows you to set each mode individually. When not disabled, each of the
ranges are from 1 min. to 1 hr. except for HDD Power Down which ranges
from 1 min. to 15 min. and disabled
Video Off In Suspend : This option is for choosing the setting in which the monitor will turn
off. The default setting is “Suspend”.
Always On The monitor will be turned on
Suspend -> Off The monitor will be turned off.
Video Off Method : This determines the manner in which the monitor is blanked. The default
setting is “V/H SYNC+Blank”.
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blank to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
Suspend Type : Options are from “1 Min”. to “15 Min”.
HDD Power Down: Options are from “1 Min”. to “15 Min”. and “Disable”. The IDE hard
drive will spin down if it is not accessed within a specified length of time.
After you have made your selection in the POWER MANAGEMENT SETUP, press the
<ESC> key to go back to the main program screen.