Lennox Hearth COUNTRY COLLECTION 506033-34 - Manual (Page 5)

5
Step 7. Plug the power cord into grounded 120 VAC receptacle. Do
not route the power cord under the stove or allow it to come in
contact with any surface of the stove.
Step 5. Plug the blower harness into plug on rear of snap switch bracket.
See Figure 20.
Step 4. Using a 9/16” wrench, slowly start to tighten the bottom heatshield
bolt. While tightening bolt, and before snug, make sure the snap
switch housing does not shift. DO NOT OVERTIGhTEN. Make
sure snap switch is making firm, flat contact with ashlip, and
does not shift. See Figure 19.
Step 6. Visually inspect wires are clear of contact with firebox. See
Figures 20 through 21.
Figure 19
Figure 20
Figure 21
Figure 18
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Tabs
Control Box
Snap Switch
housing
Blower Wire harness
Snap Switch Bracket
Snap Switch
Snap Switch harness
Bottom of Firebox