La Crosse Technology WT-5721 - Manual (Page 6)

6
III. PROGRAM MODE
To enter the Program Mode hold down the “SET” button for 1 second, until the time zone (“-5”
default) flashes in the lower left. The Program Mode Guide is laid out in a manner that allows
you to program each function separately, or you can follow the instructions entirely to program
the projection alarm. Complete programming is usually done for the initial set-up, and will
require you to skip step 1 of programming sections III through VIII. Press and release the
“SNOOZE” button at any time to exit the Program Mode, or wait approximately 15 seconds for
the projection alarm to automatically return to normal operation.
A. PROGRAMMING SEQUENCE
1. Time Zone Setting
2. Daylight Saving Time ON/OFF
3. Adjustable Snooze
4. Hour Setting
5. Minute Setting
6. Year Setting
7. Month Setting
8. Date Setting
9. Day Setting
10. 12/24-hour Mode
B. FUNCTION BUTTONS
There are 7 function buttons located on the front of
the projection alarm and one on the top. The
function buttons are labeled: ALM1/HOUR,
ALM2/MIN, light intensity icon, DISPL, light
direction icon, SET, MODE/+, and SNOOZE (the
top bar).
C. TIME ZONE SETTING
1. Hold down the “SET” button for 1 second, the time zone (“-5” default) will flash in the
Date LCD.
2. Press and release the “+” button to select the appropriate time zone. There are 13
time zones to choose from (based relative to the international time standard of GMT
(“Greenwich Mean Time).
3. From –5h to –8h, a US map with the highlighted time zone will also be displayed to the
right of the time display.
4. Press and release the “SET” button to confirm the time zone setting, and to advance
to DST (Daylight saving time) setting.
-4h Atlantic Time
-5h Eastern Time (default setting)
-6h Central Time
-7h Mountain Time
-8h Pacific Time
-9h Alaskan Time
-10h Hawaiian Time
-11h, -12h Next two time zones West of HAW
0h Greenwich Mean Time
-1h, -2h, -3h Three time zones West of GMT
PROJECTION
02'(