Installation of the unit, Preparing the power supply – Panasonic DMP-B500 User Manual

Page 10

Advertising
background image

VQT2J81

(ENG)

10

Installation of the unit

Open the stand and set the unit on a
horizontal and stable level surface.

≥ Use the stand in a fully opened state.
≥ The unit cannot be mounted in the car.

≥The unit does not have magnetic shielding.

Do not place the unit near televisions, personal computers or
other devices easily influenced by magnetism. Do not keep
this unit and magnetized cards (bank cards, commuter
passes, etc.) close together.

When holding the unit:

≥ Hold the unit with the stand

closed.

When moving the unit:

≥ Turn the unit off.
≥ Close the screen and the stand.

About the LCD screen

There may be 0.01 % or less chance of missing or constantly
turned on pixels, but this is not a malfunction.

Caution

≥ Do not place with the LCD screen down. Doing so may

scratch the surface of the LCD screen.

≥ Do not insert a finger between the main unit and the stand

when installing or moving this unit. Doing so may result in
fingers getting caught between the unit and the stand and
cause injuries. Especially keep an eye on children.

Preparing the Power Supply

The unit is in the standby condition (the [CHARGE] indicator
lights) when the AC power supply cord is connected. The
primary circuit is always “live” as long as the AC adaptor is
connected to an electrical outlet.

To conserve power

This unit consumes 0.4 W (Approximately 5 W when Quick
Start is set to “On”) of power even when turned off. When the
unit is not going to be used for a long time, disconnect the AC
power supply cord from the household AC outlet.

This unit can be used in places without an AC outlet, such as
outdoors, by attaching the included battery pack.
≥ The battery is not charged at the time of purchase. Charge

before initial use.

≥ The battery is designed only for use with this unit. It cannot

be used with other equipment.

Attaching the battery pack

Turn the unit off before attaching or detaching the battery pack.
≥ Attach the battery pack after you open the stand.

1 Bring in from the left, aligning the grooves.
2 Slide all the way to the right until you hear a "click".
Check to make sure it is securely fastened.

DO NOT

Using the unit connected to the
AC adaptor

Using the battery pack

AC adaptor
(included)

To a household
AC outlet

AC power supply cord
(included)

1

2

3

RELEASE

DETACH

ATTACH

RELEASE

DETACH

ATTACH

Bottom side of this unit

Battery pack
(included)

DMPB500PP-VQT2J81_eng.book 10 ページ 2010年3月16日 火曜日 午後4時8分

Advertising