Patton electronic 3088 Series - Manual (Page 40)

Introduction 40
Model 3088 Series User Manual 2 • Configuration
• Set the Model 3088 (CP) to “RocketLink Plug-and-Play CP” by setting S1 and S2 DIP switches in the ON
position as described in
figure 6 .
Figure 6. Typical RocketLink Plug ‘n’ Play Application
When the CO and CP units connect over DSL, the CP will enter a predefined default configuration (Receive
Recovered Clocking). During the negotiation process, the CO unit will configure the DTE rate/line rate on
the CP unit as defined by the settings of the CO unit.
3096RC
(CO)
3088
(CP)
DIP Switches all in ON position DIP Switches or NMS configured
according to specific application
requirements
DSL Span