ProForm 831.24745.1 - Manual (Page 7)

7
4. With the help of a second person, carefully tip
the treadmill down so that the Base (80) is flat on
the floor.
Identify the Right Upright (72) and the Right
Upright Spacer (74), which are marked with
stickers. Insert the Upright Wire (78) through the
Right Upright Spacer as shown.
See the inset drawing. Tie the wire tie in the Right
Upright (72) securely around the end of the
Upright Wire (78). Then, pull the other end of the
wire tie until the Upright Wire is routed com-
pletely through the Right Upright.
72
78
Hole
78
74
80
4
3. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (53) so the treadmill is more stable;
do
not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Base Pad (79) to the Base (80) in the lo-
cation shown with a Base Pad Spacer (25) and a
1" Tek Screw (56). Then, attach another Base
Pad (79) with only a 1" Tek Screw (56).
Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),
and the shipping bracket (C) from the Base (80).
Attach a Base Wheel (81) with the Bolt and the
Nut that you just removed.
Do not overtighten
the Nut; the Wheel must turn freely. Discard
the shipping bracket.
3
80
81
53
4
8
C
79
56
B
A
79
25
2. Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),
and the shipping bracket (C) from the Base (80).
Attach a Base Wheel (81) with the Bolt and the
Nut that you just removed.
Do not overtighten
the Nut; the Wheel must turn freely. Discard
the shipping bracket.
Cut the tie off the Upright Wire (78).
80
78
Tie
4
C
8
2
81
56
Wire
Tie
Wire
Tie
78
72