Problems and solutions for programmed recordings, Problem solution, Programming a recording (timer) – Philips VR620/07 User Manual

Page 50

Advertising
background image

46

6

Switch off with STANDBY/ON m .
The programmed recording will only function when the video
recorder is switched off with STANDBY/ON m .
If any of the TIMER blocks are in use, ' k ' will light up on the video
recorder display.

Problems and solutions for programmed
recordings

PROBLEM

SOLUTION

The video recorder
does not react

b

While a programmed recording is being made, you cannot operate your video recorder manually.
If you want to cancel the programmed recording, press STANDBY/ON m .

'

k

' will flash in the

video recorder display

b

The video recorder was switched on several minutes before the start of a programmed recording.
Switch off the video recorder with STANDBY/ON m . A programmed recording (timer) will
only function if the video recorder is switched off.

b

No cassette was inserted. Insert a cassette and switch off the video recorder using

STANDBY/ON m .

Cassette is ejected
during recording

b

The end of the tape was reached during recording.

The '

PROT' error

message appears
briefly in the display
then the cassette is
ejected

b

A cassette was inserted with the security tab removed. Undo the erase protection (chapter
'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different
cassette.

Error message: '

FULL'

b

If this error message appears after pressing TIMER k , then all TIMER blocks are already
programmed. No more recordings can be programmed. If you want to clear or check a
programmed recording (TIMER block), select it with ;qP or P r= .

Programming a recording (TIMER)

Advertising