ProForm TrainerCycle PFEX38440 - Manual (Page 8)

8
8. Push down the lever (not shown) on the right side of
the Seat Carriage Assembly (10), slide the Seat
Carriage Assembly into the Frame Rail (52), and then
pull the lever back up.
Attach a Bumper (51) to the Frame Rail (52) with an
M4 x 20mm Screw (56). Then, press the Frame Rail
Endcap (50) into the end of the Frame Rail.
10
Lever
50
52
51
8
56
9. The Console (4) requires four 1.5V “D” batteries (not
included); alkaline batteries are recommended.
Remove the two battery covers from the Console.
Next, insert four batteries into the battery compart-
ment. Make sure that the batteries are oriented as
shown by the diagrams inside of the battery com-
partments. Then, reattach the battery covers to the
Console.
Attach the Book Holder (23) to the Console (4) with
two M4 x 12mm Screws (41) as shown.
9
4
41
23
Batteries
Battery
Covers
10. While another person holds the Console (4) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (42). Insert the
excess wire harness down into the Upright (2).
Attach the Console (4) to the Upright (2) with four M4
x 12mm Screws (41). Be careful to avoid pinching
the wire harnesses.
10
4
2
Wire
Harness
41
41
42