Precor C846 User Manual
Page 12
page 12
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
8.
Attach the seat pad. (C846 Recumbent only). If you purchased a C846
Recumbent Cycle, you will need to attach the upper portion of the seat pad
by taking the following steps:
a. Position the seat pad as shown in Diagram 4, #1 and slide it along the
seat frame until it comes to rest. The upper portion of the pad rests on the
top of the two seat frame posts.
CAUTION: The next step is critical! The back of the seat pad has nut
inserts for the buttonhead screws (D). It is critical that you hand thread
the four screws. Otherwise, the nut inserts can be stripped and the
seat pad will have to be replaced at your cost. Improper assembly is
not covered by the Precor Limited Warranty.
b. Insert four buttonhead screws (D) and finger tighten.
c. With the four buttonhead screws (D) properly threaded, use the supplied hex
key (E) to alternately tighten each screw until it is snug against the seat frame.
9.
Adjust the seat. Diagrams 5 and 6. On the C846 Upright, you simply pull up
on the seat to raise it or pull the pop pin out while you lower it.
Diagram 5
Adjusting the seat on the
C846 Upright.
Seat post
Seat post support
Seat post adjustment
pin “Pop pin”
Diagram 4
C846 Recumbent seat pad
installation.
Seat frame (post)
Upper portion of Seat pad
2
1
3
Seat
³⁄₁₆
- inch hex key (E)
Buttonhead screw (D)