Plantronics Discovery 925 - Manual (Page 11)

7
en
earpiece Controls
Turn on the earpiece Press and hold the call control button for 2
seconds until the indicator glows blue. If earpiece
flashes red 3 times when you turn on the earpiece
then the battery is very low and should be
recharged.
note When your earpiece is in standby mode, the indicator
is off. To confirm that your earpiece is on, press any button.
You should see a blue light flash.
Turn off the earpiece Press and hold the call control button for 4
seconds until the indicator glows red. When
power is off, indicator stays off.
note If you’re wearing the earpiece, you hear ascending
tones when the power turns on and descending tones when
the power turns off.
Answer or reject
a call
When your earpiece rings, tap the power button
once; you should hear 1 low tone.
To reject a call and send the caller to voice mail,
press the call control button for 2 seconds.
note Your phone may ring before your earpiece rings.
Wait until you hear the ring in your earpiece to press the call
control button and answer the call.
End a call During active call, tap the call control button.
Make a call When the earpiece is paired to your phone and in
range, enter phone number on your phone and
press send. The call automatically transfers to
your earpiece.
Transfer a call
between earpiece
and phone
During an active call, press and hold the call
control button for 2 seconds. You will hear a
single low tone followed by a double low tone.