Panasonic DMP-BD10A - Manual (Page 11)

11
RQT8997
Easy Setting
After connecting your new player and pressing the power button, a screen will appear prompting you to perform setup for the basic settings.
Please follow the guide and perform setup.
Remote control setting
You can configure the remote control TV operation buttons to turn the television on/off, change the television input mode, select the television
channel and change the television volume.
Change the remote control code on the main unit and the remote control (the two must match) if you place other Panasonic products close
together. Use “1”, the factory set code, under normal circumstances.
Preparation
Turn on the television and select the appropriate video input on the
television.
1 Press [ Í BD POWER].
Setup screen appears.
2 Follow the on-screen instructions and make
the settings with [
3, 4, 2, 1] and [ENTER].
“On-screen Language”, “TV Aspect” and “Speaker” are set.
You can also change their settings individually ( “Display”
and “Connection” tab ➡ 22–23).
≥You can perform this setup
anytime by selecting “Easy
Setting” in Setup menu
(➡ 21,“Setup” tab).
Setting the television operation
Point the remote control at the television.
1 While pressing [RETURN], enter the code with the numbered
buttons.
e.g., 01: [0] ➡ [1]
2 Test by turning on the television and changing channels.
≥If your television brand has more
than one code listed, select the
one that allows correct operation.
≥If your television brand is not listed
or if the code listed for your
television does not allow control of
your television, this remote control
is not compatible with your
television. Use the television’s
remote control.
Manufacturer and Code No
Panasonic
National
QUASAR
01/02
PHILIPS (RC-5) 03
RCA 05
SAMSUNG 14/18/19
FISHER 10 SANYO 10
GE 05 SHARP 06/07
GOLDSTAR 15/16/17 SONY 08
HITACHI 12 SYLVANIA 03
JVC 11 THOMSON 05
LG 15/16/17 TOSHIBA 09
MAGNAVOX 03 ZENITH 04
MITSUBISHI 13
When other Panasonic products respond to this remote control
1 Press [SETUP].
2 Press [ 3, 4] to select “Setup” and press [1].
3 Press [ 3, 4] to select “Remote Control Code” and press
[ENTER].
4 Press [ 3, 4] to select the code (1, 2, or 3) and press [ENTER].
5
To change the code on the remote control
While pressing [ENTER], press and hold the numbered button ([1],
[2] or [3]) for more than 2 seconds.
6 Press [ENTER].
When the following indicator
appears on the unit’s display
and you are unable to operate
the unit
≥Press and hold [ENTER] and the
indicated number button at the
same time for more than 2
seconds.
ENTER
TIPS
NOTE
Setup Remote Control Code
Press “ n” and “ENTER” together
for more than 2 seconds on the remote.
Disc
Setup
NOTE
D
R
The unit’s remote control code
Getting started 11 Easy Setting / Remote control setting
Gettin
g
star
ted
DMP-BD10PP_Book1.book Page 11 Friday, April 6, 2007 7:06 PM