Panasonic DMR-BS750 - Manual (Page 34)

34
RQT9434
Advanced recording
§ This function can only be used when two satellite cables are
connected to the unit (
> 17) and “Two cables ( Same signal )”
has been selected in Auto Setup ( > 18, 87).
Operation during Recording
Check the
recording
programme Press [STATUS ].
e.g., while 2 programmes simultaneous
recording
Switch the
input Press [INPUT SELECT].
Switch to
other
channel
§
Press [ W X CH].
≥Other operation (> 20)
≥During the recording of an encrypted
broadcast, you cannot view or record another
encrypted broadcast. (
> 22)
Display the
recording
programme
on the TV
screen It is necessary to display the recording
programme onto the TV screen to perform
operations such as pause.
≥If the input was switched:
Press [INPUT SELECT].
≥If the channel was switched:
Press [ W X CH].
≥If the drive was switched:
Press [DRIVE SELECT].
To stop
recording It is necessary to display the programme you
want to stop on the TV screen. (
> above)
Press [ ∫].
≥From the start to the end of the recording is
called one title.
To pause
recording It is necessary to display the programme you
want to pause on the TV screen. (
> above)
Press [ ;].
≥Press again to restart recording.
You can also press [ ¥ REC] to restart.
(Title is not split into separate titles.)
≥If paused while recording in DR mode, the
paused part may become a still picture for a
moment during playback of that programme.
Perform 2
programmes
simultaneous
recording
§
Record other programme with
steps 1–3 on page 22.
≥One of the 2 programmes needs to be digital
broadcasting recorded with DR mode.
≥Channel switch / input switch while performing
2 programmes simultaneous recording will
switch between the 2 recording programmes.
Recording programme
displayed on the TV screen
3 KiKa REC2
ZDF
1
REC1
D D H
Recording programme not
displayed on the TV screen
“REC1” and “REC2” will light
REC1
REC2
Unit’s display
DMRBS850&750EG-RQT9434-L_eng.book 34 ページ ２０１０年１月１４日 木曜日 午後４時２１分