ProForm L.E.X PFEL25070 - Manual (Page 8)

8
7. The Console (13) requires two ÒAAÓ batteries (not
included). Alkaline batteries are recommended.
To install batteries, first slide up the Battery Cover
(14). Carefully remove the battery clip from the
Console (13). Insert two batteries into the battery clip.
Make sure that the negative ends of the batteries
(marked ÒÐÓ) are touching the springs. Replace the
battery clip and close the Battery Cover.
8. Make sure that all parts of the L.E.X. are properly
tightened. Place a mat under the L.E.X. to protect
the floor or carpet from damage.
14
13
7
Battery
Clip
Batteries
MAINTENANCE
Inspect and tighten all parts of the L.E.X.
regularly. Replace any worn parts immediately.
For continued smooth operation of the L.E.X., the
Stabilizer (4) should be kept clean. Using a soft cloth
and mild detergent, clean any dust and residue that
may build up where the Wheels (60) move on the
Stabilizer. Other components of the L.E.X. can also be
cleaned in this manner.
IMPORTANT: Never use abrasives or solvents to
clean the L.E.X.. To prevent damage to the con-
sole, keep liquids away from the console and
keep the console out of direct sunlight.
LUBRICATING THE HANDLEBARS
If a squeaking sound is heard when the Handlebars
(10, 11) are moved, a small amount of grease should
be applied. Refer to the drawing below. Turn the
Resistance Knob (30) counterclockwise and remove it.
Remove the Star Washer (29). Using pliers, grip the
head of the Carriage Bolt (32) and remove it. Apply a
thin film of grease to both sides of the Handlebar Caps
(28). Reattach all parts, making sure that they are in
the positions shown.
4
60
Apply
Grease
32
28
28
10
11
30
29