Panasonic AG-HPG20P - Manual (Page 105)

The underlined settings are the factory mode settings.
105
Menu
DISPLAY SETUP screen (continued)
Item Description of settings
UPCON MODE This is used to select the aspect ratio for up-conversion to HD-SDI output.
S-PANEL:
The magnification is changed while matching the input size to the output size along
the vertical axis. (The aspect ratio is unchanged.)
CROP:
The magnification is changed while matching the input size to the output size along
the horizontal axis. (The aspect ratio is unchanged.)
STRETCH:
The magnification is changed while matching the input size to the output size along
the horizontal and vertical axis. (The aspect ratio may be distorted.)
EDGE CROP This is used to set the cutting position of down-converted SD-SDI output and VIDEO
output images when the setting menu “DOWNCON MODE” is set to “SIDE CROP”.
–10 ~ 0 ~ +10
<Note>
LCD monitor remains in “LETTER BOX” size.
WFM This is used to switch the display of the waveform monitor.
OFF:
No display
WAVE:
Wave shape display
VECTOR:
Vector display
When WFM is assigned to [USER], the setting value circulates as follows.
When the WFM setting value is OFF:
OFF → WAVE → VECTOR → OFF…
When the WFM setting value is WAVE:
OFF → WAVE → OFF…
When the WFM setting value is VECTOR:
OFF → VECTOR → OFF…
<Note>
Even when the WFM display is switched on [USER], the “WFM” setting value remains
the same.
•
•
•
REC COUNTER This is used to select the counter operation during recording.
TOTAL:
Counting continues until it is reset on [RESET].
CLIP:
The counter is reset when the shooting starts, then counts the time of the shooting
unit.
<Note>
This is displayed only during recording standby or recording.
CARD FUNCTIONS screen
Item Description of settings
USER FILE Up to 4 sets of setting values on the setting menu can be saved on the SD card. Titles
can be given to the files which have been saved. (Page 34)
SD CARD FORMAT This is used to format SD cards. (Page 33)