Panasonic AG-HPG20P - Manual (Page 15)

15
Introduction
Be absolutely sure to check the date, time and time zone, and set them if necessary.
The calendar and time zone affect the management and playback sequence of the data content which
has been recorded. Before recording, set and check year/month/day, time and time zone. (Page 27)
No compensation can be made for video recordings.
The manufacturer will not provide any compensation in the event that images fail to be recorded due to
trouble while the unit and P2 card are being used.
Concerning copyrights
You may use the images and sound which you have recorded for your own personal enjoyment only;
under copyright laws, you may not use them for any other purpose without the permission of the
copyright holders.
IEEE1 cable connection
Be sure to observe the following when connecting the IEEE1394 cable (optional). (Improper connection
may cause malfunction in this unit and external devices)
Before connecting or disconnecting the IEEE1394 cable, you must turn off the power of all devices
connected to the unit.
Devices equipped with earth terminals must be used in the grounded condition (or in the connected
condition to the commonly-used GND).
When connecting the unit to a component which uses a 4-pin type of connector, be sure to connect this
unit’s connector (6-pin type) first.
IEEE1394 cable connector has a direction.
When connecting the unit to a component which uses a 6-pin type of IEEE1394 connector, be sure to
check the shape before connection as below
IEEE1394
connector
IEEE1394
cable edge
IEEE1394
connector
(Wrong)
(Correct)
IEEE1394
cable edge
During recording or playback in AVC-Intra100 and AVC-Intra50 modes, input/output from the DVCPRO/
DV input/output connector (IEEE1394) is not possible.
•
•
•
•
•
•
•
•
Note concerning illustrations in these instructions
• Illustrations (portable recorder, menu screens, etc.) in these operating instructions differ slightly from the
actual portable recorder.
References
• References are shown as (Page 15).
Each explanation, company names and product names described in these operating instructions are
trademarks or registered trademarks of each company.
About this manual
Before use