Panasonic AG-HPG20P - Manual (Page 30)

0
P cards (continued)
Ejecting P cards
1
Confirm P card access LED is not blinking
orange.

Open the card slot cover and raise the P
card eject button.

Push the P card eject button to remove the
P card.
1
2
P card eject button

After ejecting the P card, close the card
slot cover.
Do not eject cards or turn off the power in the
following situations: otherwise, this may cause
P2 card trouble.
1) While the orange P2 card access LED is
changing from blinking to lighting after the P2
card has been inserted
2) During recording, during the process to
complete recording or while the P2 card
access LED is blinking
3) While the P2 card access LED is blinking
(i.e. while copying, formatting, etc.)
•
In the event that a P2 card is ejected while being
accessed or formatted, “TURN POWER OFF” is
displayed on the LCD monitor. In a case like this,
turn the power off and then turn it back on.
When a card was ejected while it was being
formatted:
Re-format the card.
When a card was ejected while its data was
being accessed:
Something may have gone wrong with one of the
clips (Page 35). Check the clips, and repair the
abnormal one. (For details on repairing clips →
Page 41)
During playback, a P2 card will not be recognized
even if it has been inserted into the other empty
slot, and the P2 card access LED will not
light. After playback is completed, the P2 card
recognition process is started.
If the P2 card is ejected while thumbnails are
displayed, the thumbnail display screen will be
cleared and the normal display screen appears.
Precaution for using P cards
P2 cards must always be formatted using a P2
device prior to use.
•
•
•