Panasonic AG-HPG20P - Manual (Page 65)

Recording
65
Time code displays
You can change what is displayed in the time code
display area. (Page 80)
1
Press [COUNTER].
Each time the button is pressed, the data
changes as follows.
TC: Time code displays
UB: User’s bit value
FR: Frame rate information
No display: No data displayed
COUNTER: Counter display (Except for
playback process)
Resetting the counter value
On the normal display screen, press [RESET]
while the counter value is displayed.
When the time code display during recording
is COUNTER, you can select whether to
display the counter value by clip, or to display
the total counter value on the setting menu
“DISPLAY SETUP” – “REC COUNTER”.
Setting the recording time code
You can select the recording time code at the “EXT
TC REGEN” item on the setting menu “TIMECODE
SETUP”. For details, refer to the setting menu
“TIMECODE SETUP”. (Page 93)
Setting the recording time code
On the setting menu “TIMECODE SETUP”, set the
following time code related items. (Page 93)
TC MODE
TCG
TC PRESET
•
•
•
•
Specifying the time code (TC PRESET)
Set the time code value on “TC PRESET” so you
can record a value of your choice as the initial
setting for the time code to be used at the start of
recording.
1
Hold down [POWER] for at least 1 second to
turn the power on.

Select “OFF” on the “EXT TC REGEN” item
on the setting menu “TIMECODE SETUP”.
Basic operations on the setting menus (Page
88)

Select “CHANGE” for the “TC PRESET” item
on “TIMECODE SETUP”, and press .
TIMECODE SETUP
PUSH MENU TO RETURN
TCG
EXT UB REGEN
TC MODE
UB MODE
REC RUN
FRM.RATE
UB PRESET
VITC BLANK
THRU
>>>
EXT TC REGEN
DF
ON
CHANGE
TC PRESET RETURN

When the following screen appears, set the
time code value.
Using and , select the time code value.
PRESET : PUSH SET
1 0 : 3 2 : 2 3 : 2 4
h min s frm
TC PRESET
REC RUN
+/-
SEL
: PUSH
: PUSH /
/
Using , move to the next digit, and using
and , select the time code value again.
1 0 : 3 2 : 2 3 : 2 4
h min s frm
TC PRESET
REC RUN
PRESET : PUSH SET
+/-
SEL
: PUSH
: PUSH /
/
If [RESET] is pressed while setting the time code,
the time code value will be reset to zero.
(Continued on the next page)
•
•