Powermatic 1632 - Manual (Page 7)

7
RECEIVING THE SANDER
Remove the sander from its crate and inspect for
damage to ensure all parts are intact. Any damage
should be reported to your distributor and shipping
agent immediately upon discovery.
Before proceeding with installation, read your
instruction manual thoroughly. Familiarize yourself
with correct set-up, maintenance and safety
procedures.
Contents of crate:
1 Wide belt sander
1 Infeed roller assembly
1 Outfeed roller assembly
1 Side support
1 Sanding belt
1 Toolbox containing oil gun, door latches,
and draw bar (for the graphite pad)
INSTALLATION
If using a forklift, run the forks between the upper
cabinet and the conveyor belt. Level the machine
and bolt it to the floor with high quality anchor bolts
through the mounting holes located on the four
corners of the base.
Remove the protective coating from the rollers with
a soft cloth moistened with a good commercial
solvent. DO NOT USE acetone, gasoline, lacquer
thinner or any type of flammable solvent. Do not use
an abrasive pad.
ELECTRICAL CONNECTIONS
WARNING: All electrical connections
should be made by a qualified
electrician. Failure to comply may
result in serious injury and/or damage
to the machine and property. The
machine must be properly grounded.
1.
A cable of the proper gauge should be used to
connect the sander to the power supply.
2. Remove the wiring cover and attach the
ground wire (A), Figure 1.
3. For 3 Phase: Connect the three power leads
(B) to the wiring board.
For 1 Phase: Connect the two power leads to
the wiring board.
4. This machine should be hard wired into a
dedicated circuit with a properly rated breaker
according to your local code.
5.
Replace wiring cover.
!