Philips SELECON PL1IRR - Manual (Page 5)

3
PL1IRR Remote Control User’s Guide
PREFACE
About this Guide
The document provides installation and operation instructions for the following product:
• PL1IRR Remote Control (includes two AAA batteries and user’s guide)
Please read all instructions before using this product. Retain this manual for future reference. Additional information
for PL1 LED Luminaires including product descriptions may be downloaded at www.seleconlight.com
Product Description
The PL1IRR Remote Control is used to remotely program and control presets (1 through 6 and Off) of PL1 LED
luminaires (IR-enabled models only) over an unobstructed range of approximately 100 feet. IR-enabled PL1 LED
Luminaires have an integrated infrared (IR) receiver that allows them to receive IR commands from the PL1IRR
Remote Control. Using the Remote, colors (full color mixing)/presets/intensity can be programmed/selected, raised
and lowered, and fixtures may be turned On and Off.
Before Using the Infrared Remote
Install two AAA batteries (included) before operation. Refer to Figure 1 for more information.
Figure 1: PL1IRR Remote Battery Installation
PL1IRR Remote
Battery Compartment
Access Panel
AAA Battery (2 each -
supplied with remote)
+
_
To install two AAA batteries (included)
in PL1IRR remote:
Step 1. At rear of remote, remove battery
access panel by sliding it as
indicated.
Step 2. Note orientation of batteries as
indicated in battery compartment
of remote.
Step 3. Install batteries.
Step 4. Reinstall battery access panel.
Step 5. Remote is ready for use.
WARNING! PL1IRR Remote contains a
Class 2 laser. Do not stare or look directly
into laser beam.
+
_
Slide battery access panel away
from remote to install batteries.
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
LASER DIODE
WAVELENGTH: 630 - 680 nm
MAX OUTPUT: <5 mW