PYLE Audio PT655E - Manual (Page 5)

OPERATING PROCEDURES
E Q TAP E TU NE R
P H ON O C D TU NE R P LAY R E C
TAP E
P LAY R E C
E Q
C D
L
R
RE MOT E S YST EM
_
A U D I O
L
RIGHT LEFT
_
AV1 AV2
L
R
INTEGRATED CIRCUIT
AC 220V - 230V ~50Hz
S P E A K E R S6 ~ 8 Ω
GN D
EQ
EQUALIZER
INTEGRATED CIRCUIT
AC 220-230V~50Hz
POWER CONSUMPTION: 10W
* Switch on the Amplifier or the sound source.
* Select “EQ” from function selection column at the amplifier or the processor, the relative light will be seen when selected.
* Switch on the Equalizer by pressing the Power switch (1).
* Bars of spectrum display in equalizer will be jumping.
* Press DISPLAY/MEMORY switch, 5 different kinds of display will be shown.
* When selecting the pre-memorized sound level curves, pressing the SOUND MODE SWITCH (6-9), the relative word
and sound curve will be seen. A few seconds later, the display will change to spectrum mode automatically.
* If you want to adjust the your favourite sound level curve, press EQUALIZER SETTING(◄)/ (►), the display will
change from spectrum mode to EQ mode. Choose the frequency firstly, you can adjust the frequency band alternatively
(by pressing ALT) or each succeeding frequency band (by pressing FINE). Then pressing EQUALIZER SETTING (▲)/
(▼) to adjust your favourite sound level. After adjustment, press DISPLAY/MEMORY switch, “MEMO” will be seen on
the display and press A_E preset. Your 5 favourite sound level curves can be stored in the User Preset Switch.
* Press User Preset Switch to take your pre-memorized sound level curve.